How To Determine Your Ring Size
You can use our ring sizer pictured above, to print the ring sizer, be sure that your printer is set to 100%. In other words, make sure that you have not reduced the print size in 'page set up.' You can verify that the sizer printed correctly by measuring it with a ruler; it should measure from left to right: 3 3/8 inches.
Once you have printed the sizer, you may cut it out and use it or try the following directions to measure ring size of your finger.
Step 1--Wrap a string or piece of paper around your finger.
Step 2--With A Pen Mark the point where the two ends meet.
Step 3-- Using the chart, place the end of the string on the left hand line next to the letter "A" and stretch the string along the sizer toward the numbers.
Step 4-- The pen mark on your string should line up with a number to indicate your ring size. Find your measurement on the chart below to determine your ring size.
Generally 1/16 of an inch or 1 cm increases the ring size by ½ a size
7/11/2022 01:16:15 am
Appreciaate this blog post
Your comment will be posted after it is approved.
Leave a Reply.
Marsha Rowe, is the owner & designer of Heavenly Beads & More. She's been a Jewelry Artisan since 2004, and teaching others to make jewelry since 2013.